עברית

Vulnerability Intelligence

CVE-2026-10644

Low 3.1

Published
Last modified
NVD status
Modified

Description

The Microchip SERCOM-G1 UART driver (drivers/serial/uart_mchp_sercom_g1.c), used by the PIC32CM-JH SoC family, contains an out-of-bounds write in its asynchronous (DMA) receive path. When uart_rx_enable() is invoked with a one-byte receive buffer (len == 1) and CONFIG_UART_MCHP_ASYNC is enabled, the RX-complete ISR starts a single-beat DMA transfer while a received byte is already pending in the SERCOM DATA register. On this SoC the peripheral-triggered DMA start sequencing then writes one byte past the end of the caller-supplied buffer (CWE-787). The overflowed byte's value is the UART RX data supplied by the connected serial peer (adjacent attacker), while its size and location are fixed at one byte immediately after the buffer. Exploitation requires the async UART config (not enabled by default on the in-tree PIC32CM-JH boards) and a consumer that enables RX with a one-byte buffer; impact is limited single-byte memory corruption adjacent to the RX buffer (possible crash / denial of service). The defect shipped in v4.4.0. The fix reads the first byte with the CPU and, for one-byte buffers, performs no DMA at all; for larger buffers it sizes the DMA for the remaining len-1 bytes.

Affected products

zephyrproject: zephyr

References2

Metrics

CVSS 3.1
3.1 LOW Score source: NVD CVSS:3.1/AV:A/AC:H/PR:N/UI:N/S:U/C:N/I:N/A:L
EPSS — exploit probability
0% percentile: 13 · as of 16 November 2026
CWE
CWE-787

Could this be exploited in your environment?

A patch closes the known hole. A penetration test shows what an attacker can still reach — with proof.